Installing libnfc for PN532 based NFC reader is not exactly as described in the documentation. Some information is scattered in the documentation. This installation guide has been tested with the GO2NFC GO2NFC141U NFC Reader and the Adafruit PN532 NFC/RFID controller breakout board.
1) Install the dependencies:
sudo apt-get install libusb-0.1-4 libusb-dev libpcsclite1 libpcsclite-dev libccid pcscd
2) Create the configuration directory
sudo mkdir -p /etc/nfc/devices.d/
3) Create the file /etc/nfc/devices.d/pn532_uart.conf containing
name = "PN532 board via UART"
connstring = pn532_uart:/dev/ttyACM0
allow_intrusive_scan = true
Replace ttyACM0 with ttyUSB0 if you are using the Adafruit reader.
5) Create the file /etc/nfc/libnfc.conf containing
allow_autoscan = true
6) Download the libnfc library at https://bintray.com/nfc-tools/sources/libnfc. Decompress the archive somewhere. Go into the libnfc-x.x.x directory.
7) Build the library
sudo ./configure --sysconfdir=/etc --prefix=/usr --with-drivers=pn532_uart
sudo make
sudo make install
8) Test your installation. Execute the command utils/nfc-scan-device. You should get an output similar to this one:
nfc-scan-device uses libnfc 1.7.1
1 NFC device(s) found:
- pn532_uart:/dev/ttyACM0:
pn532_uart:/dev/ttyACM0
The post How to Install libnfc for PN532 NFC Readers on Linux appeared first on L'Antre du Tryphon.
